Messages What to do
The combination of the IP
address and the subnet mask is
invalid.
For details, see your
documentation.
Make sure you have entered the correct values for the IP address and the default
gateway.
If you do not know the correct values, contact your network administrator.
Recovery Mode Firmware update failed, and the printer started in recovery mode. Follow the steps
below to update the firmware again.
1. Connect the computer and the printer with a USB cable (updates cannot be
performed over a network connection when the printer is in recovery mode).
2. Download the latest firmware from the Epson website, and then start the update.
When a Maintenance Call/Service Call Occurs
Error messages What to do
Maintenance Request: Replace Parts
Soon
XXXXXXXX
A part used in the printer is nearing the end of its service life.
Contact your dealer or Epson Support and tell them the maintenance request
code.
You cannot clear the maintenance request until the part is replaced. A printer
error occurs if you continue to use the printer.
Maintenance Request: End Of Parts
Service Life
XXXXXXXX
Printer error.
For details, see your documentation.
XXXXXX
Printer errors are displayed in the following situations.
❏ The power cable is not connected securely
❏ An error that cannot be cleared occurs
When a printer error occurs, the printer automatically stops printing. Turn off
the printer, disconnect the power cable from the outlet and from the AC inlet
on the printer, and then reconnect. Turn on the printer again multiple times.
If the same call for service is displayed on the LCD panel, contact your dealer or
Epson Support for assistance. Tell them the call for service code is "XXXXXX".
SC-F6400 Series/SC-F6400H Series User's Guide
Problem Solver
85
To Next Page
Loading...
Need help?
General