Settings item Setting/Additional Explanation
Paper Source Settings
Roll Paper Setup
Auto Loading On, Off
Cut Settings
Auto Cut On, Off
Print Cutting Guideline On, Off
If Auto Cut is set to Off, you can choose whether or not (On/Off) to print
cutting lines on roll paper. Cutting lines are not printed if Auto Cut is set to
On or when printing cut sheets or poster board.
Wait for Cut Between Pages On, Off
Cut for Borderless Print Two Cuts, One Cut
Quick Cut On, Off
Cut Mode Normal, Quiet
Margin Refresh On, Off
Before printing with borders, select whether or not (On/Off) to
automatically cut the leading edge to remove ink stains that may have
been left by previous borderless printing.
Roll End Option Continue, Stop Printing, Reprint
Select the action to perform for a roll after replacement: print the
remaining data (Continue) / do not print (Stop Printing) / print again from
the beginning (Reprint).
Reprint is only available when the optional hard disk unit is installed.
Take-up After Cut On, Off
This item is only displayed when the take-up reel unit is connected.
U “Removing Paper from the Auto Take-up Reel Unit” on page 41
Error Notice
Paper Size Notice On, Off
Paper Type Notice On, Off
Detect Paper Meandering On, Off
Platen Gap Offset Standard, Wide, Wider, Widest
Custom Paper Setting
01-30 Display Registered Number & Registered Media Name
From the printer, you cannot change paper setting information registered
using the driver or other software.
Change Name Displays the media name registration screen
Change Reference Paper Displays the reference paper type
SC-P9500 Series/SC-P7500 Series User's Guide
Menu List
107
To Next Page
Loading...
Need help?
General