Basic Operating
Procedures (Mac)
Printing Procedure
This section describes the basic procedure to print
using the printer driver from a computer.
Basic Printing Procedure
A
Turn on the printer, and load the paper.
U “Loading Roll Paper” on page 29
U “Loading paper into the auto sheet feeder”
on page 35
U “Loading Cut Sheet(1 sheet)” on page 39
B
When you have created the data in the
application, click Print in the File menu.
C
Click Show Details (or ) at the bottom of
the screen.
Note:
If page settings are not displayed in the print
dialog, click the "page settings" option (e.g., Page
Setup) in the File menu.
D
Check that this printer is selected, and then set
the paper size.
There are three options available for each paper
size. For example, if you click A2, the following
three options are displayed.
❏ A2
❏ A2 (Retain Scale)
❏ A2 (Roll Paper Banner)
Normally, you should select the option without
parenthesis (A2 in the example above). Select
one of the other two options in the following
situations.
Retain Scale
In the following procedure, the PDF or image
data may be printed at a slightly reduced size
even if the output size is Same as Paper Size.
This is done to secure the necessary margins (3
mm on each side) for this printer. Select this
when you want to print at the full size without
any reduction.
Roll Paper Banner
Select to make long prints on roll paper using
banner printing software.
SC-T3100M Series/SC-T5100 Series/SC-T3100 Series/SC-T5100N Series/SC-T3100N Series/SC-T2100 Series User's Guide
Printing with the Printer Driver from Your Computer
54
To Next Page
Loading...
Need help?
General