Replacing Ribbon Cassettes
69
Replacing Ribbon Cassettes
When the back printing unit is installed, replace the Ribbon cassette if back printing is too light.
See the following section for the replacement Ribbon cassette.
U “Consumables and Optional Products” on page 138
Ink Ribbon Replacement Time
When using an ink ribbon, back printing is light.
A different ink ribbon is used to print the first and second lines during back printing. If the first line is too light,
replace the Ribbon cassette that is further inside the back printing unit. If the second line is too light, replace the
ribbon cassette at the front.
Replacement Procedure
A
Check that the p light on the Operation panel is lit.
Note:
Do not perform back printing if the Ribbon cassette is not inserted.
Otherwise, paper could be jammed or the back printing unit could be damaged.
The ink ribbon can still be used The ink ribbon needs to be replaced
Tip:
There are no light indications or error messages when it is time to replace the ribbon.
!
Caution:
When replacing the Ribbon cassette, do not touch the part with a warning label attached. Because it reaches high
temperatures, burns could occur.
To Next Page
Loading...
Need help?
General