Epson TM-T70-i Technical Reference Guide

Chapter 2 Setup
41
2
Setting the DIP Switches
On this printer, you can make various settings with DIP switches.
Setting Procedure
Follow the steps below to change the DIP switch settings.
1
Make sure the power supply for the printer is turned off.
2
Unscrew the screw to remove the DIP switch cover from the base of the
printer.
3
Set the DIP switches, using the tip of a tool, such as a small screwdriver.
4
Attach the DIP switch cover, and screw it in place.
CAUTION
Before you remove the DIP switch cover, turn the printer off.
Otherwise, a short-circuit may cause the printer to malfunction.
DIP switch settings are enabled only when the power is turned on or the printer is reset via
the interface. If the settings are changed after that, the functions will not change.
DSW1
DSW2
DIP switch 2
DIP switch 1

Epson TM-T70-i Specifications

General

Type	POS printer
Character size	1.69 x 3.38 mm
Print technology	Thermal
Wi-Fi	No
Ethernet LAN	Yes
Ethernet LAN data rates	10, 100 Mbit/s
USB connector	Micro-USB, USB Type-A
Standard interfaces	USB 2.0
USB 2.0 ports quantity	1
Connectivity technology	Wired
Mean cycles between failures (MCBF)	52000000
Internal memory	256 MB
Autocutter durability	1.5 million cuts
Mean time between failures (MTBF)	360000 h
Voltage	24 V
Product color	Black

Weight and Dimensions

Depth	194 mm
Width	125 mm
Height	114 mm