Epson TM-U220-i Technical Reference Guide

80
Settings for Spooler
To use the spooler with this product, you need to enable the spooler using EPSON TMNet
WebConfig.
This section gives an overview of the setup procedure.
1. Connect this product to the network
Connect this product to the network and turn on the power.
2. Start EPSON TMNet WebConfig
On the setup computer, enter the following into the address bar of your Web browser to start EPSON
TMNet WebConfig.
When SSL is disabled: http://This product's IP address/webconfig
When SSL is enabled: https://[This product's IP address]/webconfig
( U "Starting EPSON TMNet WebConfig" on page 97
)
3. Set the Spooler
Make spooler operation settings from [Settings] on the [Web Service Settings] menu.
Select [Enable] from [Spooler].
Set the number of retry times and the retry interval when the printer is not ready to print in [Retry
Settings].
After making settings, click [Apply] at the bottom of the screen. The settings are saved to this
product. Settings are n
ot enabled unless you click [Apply].
( U
"Web Service Settings - Spooler - Settings" on page 104)
PHP cannot be used if the spooler is enabled.

Epson TM-U220-i Specifications

General

Type	POS printer
Color	Yes
Print technology	Dot matrix
Wi-Fi standards	802.11b, 802.11g, Wi-Fi 4 (802.11n)
Maximum roll diameter	83 mm
Standard interfaces	Ethernet, Parallel, RS-232, RS-485, USB, Wireless LAN
Serial interface type	RS-232, RS-485
Connectivity technology	Wired & Wireless
Electromagnetic compatibility	VCCI class A, FCC class A, CE marking, AS/NZS 3548 class B
Mean cycles between failures (MCBF)	18000000
Safety	UL, CSA, TÜV (EN60950)
Mean time between failures (MTBF)	180000 h
Product color	Gray

Weight and Dimensions

Depth	248 mm
Width	160 mm
Height	138.5 mm