1. CONVEYANCE
1. Before conveyance, move the main unit undermost, set it in the center of the base unit and secure it by
tightening the slide lock.
Side of examiner Side of examinee
1. Main unit
2. Base unit
3. Slide lock
4. Chinrest
5. Handle
2. The slide lock can be tightened by pushing it up and rotating it in counterclockwise direction.
3. At the time of conveyance, hold the back and front of the base unit (the cutout of the front side and the
handle under the chinrest) with both hands securely. Do not hold the headrest, chinrest or LCD monitor
because it can result in deformation or malfunction of them.
4. Do not drag the power cord with being attached to the main unit. It can result in malfunction of the device
caused by fall or drop, or personal injury if the cord is stuck or stepped on.
2. INSTALLATION
1. Do not expose the view window of the device directly to the sunlight or bright lighting from other sources.
Great care should be taken because the measurement cannot be carried out if the examinee is
exposed to strong light or glare during the measurement and his/her pupil contracts too small.
2. Do not operate it at the place where it is either dusty or grubby.
Environment with extremes in heat and humidity should also be avoided. In case of using the device, fulfill
the environmental conditions at the time of unpacking and use.
3. Keep away from the place which stores chemicals or which emits gas.
4. Keep away from the sites which may experience strong vibrations or sudden shocks.
5. It can result in malfunction if the device is accidentally overturns. Also, it is very dangerous if it is dropped
on your foot etc. Do not store it at the unstable or high place.
To Next Page
Loading...
Need help?
General
