To Next Page

To Previous Page

Page 42

Code 97508I-1 V07_09

VDSVDS

VDS

VDSVDS

VDS

ADVANCED PROGRAMMING: Door lock-release times on button panels

To programme the activation time follow the steps below:

1. With the power supply disconnected, execute a short circuit between the ’Bs’ and ‘-’ (negative) terminals on the

amplifier (or press the exit button if available).

2. Maintaining the short-circuit induced above, connect the system’s power supply (at this point it will no longer be

necessary to maintain the short circuit or hold down the button).

A confirmation tone will sound once you enter programming mode.

3. Following the confirmation tone, the lock-release time as currently programmed from the residence will be

indicated by way of a number of beeps at 0.5 second intervals.

4. Once these indicator tones have concluded, or before they conclude, press any button on the panel, with one press

for each second to be programmed (from 1 to 99 seconds).

To programme the lock-release time from the exit button , while in time programming mode, (having finished

programming the lock-release time from the residence or following the indicator tones), wait 5 seconds before taking

any other action.

5. At this time a new confirmation tone will sound indicating the change to entrance hall lock-release programming

mode , then subsequently emitting the aforementioned beeps detailing the time programmed.

6. Once these indicator tones have concluded, or before they conclude, press any button on the panel, with one press

for each second to be programmed (from 1 to 99 seconds).

To exit programming mode, wait 5 seconds without pressing any key. A ‘MUOK’ tone will sound to indicate that you have

exited time programming mode.

If time programming mode is accessed and no button is pressed, the user will automatically exit after 30 seconds.

There are two programmable lock-release activation times:

- Lock-release time set from the residence.

- Lock-release time set from the exit button (connected to the ‘BS’ and ‘-’ terminals).

Fermax VDS Technical Manual

Other manuals for Fermax VDS