Name: Firstech CM7200
Brand: Firstech
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Testing The DAS Sensor

STEP 1: Turn the ignition off and Arm/Lock the system.

STEP 2: Wait 30 seconds then test the impact sensitivity.

FT-EZGO Setup

The FT-EZGO from Firstech will unlock/disarm the vehicle when in range. It is capable of proximity lock/arm

and unlock/disarm when in or out of range off the vehicle. There is a manual override button located on

the back of the EZ-GO remote. It will lock/arm, unlock/disarm by press and releasing the button for ½ of

a second (0.5 seconds). It will also trigger the trunk release output by press and releasing the button for ½

second (0.5 seconds) then holding for 2.5 seconds.

Installing The FT-EZGO

STEP 1: Set Option 1-14 to Setting 2, 3 or 4

STEP 2: Connect included Blue 6 Pin (With Ground Wire) to Black 6 Pin to control module. If connecting

to a 4 Pin to 4 Pin antenna, use the included 6 Pin to 4 Pin adapter.

STEP 3: Connect the ground wire from the included 6 Pin to 6 Pin cable to vehicle’s ground. Warning:

Failure to connect this wire WILL result in damage to your FT-EZGO antenna (ANT-

RFID).

STEP 4: If you are using an additional RF kit the antenna cable will connect to the blue 6 pin connector

on the EZ-GO antenna either directly or using the 6 to 4 pin adapter harness included with the

EZ-GO kit.

STEP 5: Find a spot to mount your ANT-RFID on the windshield. This is recommended for optimum

range. For more specific mounting location information visit us at techfeed.compustar.com

under the Authorized Tech section document titled: “FT-EZGO Recommended Mounting

Locations.”

STEP 6: Program your EZ100-R using the standard remote programming procedure along with any

additional RF Kit remotes to the control module (Maximum 4 Remotes including EZ100-R). You

are now ready to test your FT-EZGO system.

Testing The FT-EZGO

STEP 1: Turn the proximity lock/unlock feature on by holding the button on the EZ100-R for 8-10

seconds. You will get one parking light flash and/or siren chirp. To deactivate the proximity

feature simply hold the button again for 8-10 seconds and you will get two parking light flashes

and/or chirps to indicate your feature is off.

CM7200 Master Guide

Starter System

techfeed.compustar.com

Firstech CM7200 User Manual

Questions and Answers: