FO4 - On double lock and Start: this option is design to simulate a factory keyless entry system by
providing a horn output pulse (based on the option selection of feature 3-02) each time the lock command
is sent a second time within 8 seconds of the first. In addition it will provide a horn output pulse with remote
start command and remote started confirmation.
3-09 Siren output: This feature controls the siren (+) output behavior during Arm, Disarm, and Remote
Start.
FO1 - On lock, Unlock, and Start: (default) this option will provide a (+) siren output pulse
(based on the option selection of feature 3-02) with each lock, unlock, remote start command and
remote started confirmation.
FO2 - On double lock only: This option is design to simulate a factory keyless entry system by
providing a (+) siren output pulse (based on the option selection of feature 3-02) each time the lock
command is sent a second time within 8 seconds of the first lock command.
FO3 - On lock and Unlock only: this option will provide a (+) siren output pulse (based on the
option selection of feature 3-02) with each lock or unlock confirmation.
FO4 - On double lock and Start: this option is design to simulate a factory keyless entry system
by providing a (+) siren output pulse (based on the option selection of feature 3-02) each time the
lock command is sent a second time within 8 seconds of the first. In addition it will provide a (+) siren
output pulse with remote start command and remote started confirmation.
3-10 Valet Mode: This feature will change the enter/exit valet mode procedure based on the option
selected.
FO1 - Key 5 times with Foot Brake Trigger or Remote (Lock + Trunk) while Ignition is
on: This option allows the user to enter valet mode using either method described. Note: the user
may exit valet mode with their Firstech remote (please check users guide for each
remote for valet mode exit procedure), or with the key to ignition or “on” position
and press the foot brake 10 times within 10 seconds.
FO2 - Key 5 times with Foot Brake Trigger or Remote (Lock + Trunk): This option allows
the user to enter valet mode using either method described. Note: the user may exit valet mode
with their Firstech remote (please check users guide for each remote for valet mode
exit procedure), or with the key to ignition or “on” position and press the foot brake
10 times within 10 seconds.
3-11 Auxiliary Settings: (2 Way LCD remote required) this feature enables access to AUX 3 through 7
via any Firstech 2 way LCD remote.
FO1 - Off: (Default) This option will prevent the user form activating AUX 3-7 with the Firstech 2way
LCD remote.
FO2 - On: This feature will allow the user to enable AUX 3-7 which can be activated using a Firstech
2 way LCD remote. (Please refer to the remote users guide for specific AUX 3-7 activation process)
Copyright 2014 Firstech, LLC. Page 3Copyright 2014 Firstech, LLC. Page 3Copyright 2014 Firstech, LLC. Page 39
CM7200 Master Guide
Starter System
techfeed.compustar.com
To Next Page
Loading...
Need help?
General
