22
December 2011
esourcebook.dealerconnection.com
RE&T: 2013 Source Book
Escape
Escape
Comfort/Convenience
2013
BLIS (Blind Spot Information System) with
Cross-traffic Alert
BLIS
• Alertsthedriverifanothervehicleentersthe“blind
zone” by utilizing two radar sensors located behind
each rear wheel and concealed by the rear fascia
• Blindzoneextendsfromtherearviewmirrorsrearward
to approximately 10 feet behind the rear bumper
• Eachexteriorrearviewmirrorisequippedwithan
amber indicator light
– Mirror indicator illuminates when a vehicle in an
adjacent lane enters the blind zone from behind
• Systemwillnotbeactivatedbyanovertaken/passed
vehicle unless that vehicle remains in the zone for
more than 3 seconds
• Systemisautomaticallyengagedwhenthevehicle
is placed in Drive and is not designed to detect
pedestrians or cyclists
• Systemcanbeturnedoffthroughtheleftinstrument
cluster screen but defaults to “on” when the vehicle
is restarted
• Ifaradarsensorbecomesblockedbywetsnowor
mud, the blind spot alert indicators will illuminate
and the message center will display:
–CLEANRADAR—SEEMANUAL
Cross-traffic Alert
• Warnsthedriverofapproachingvehicleswhen
slowly backing out of a parking spot
– Mirror indicator is illuminated and a series of tones
are sounded if an oncoming vehicle is detected
– Mirror indicator light will illuminate in the left
or right exterior mirror to indicate direction of
oncoming vehicle
– Depending on the direction in which an
approaching vehicle is detected, the message
center will display:
•VEHICLECOMINGFROMRIGHT
•VEHICLECOMINGFROMLEFT
• Automaticallyengageswhenvehicleisplaced
in Reverse to detect moving objects within an
approximate65'rangefromeithertheleftorright
side of the vehicle
– Not designed to detect pedestrians or cyclists
• Ifaradarsensorbecomesblockedbymud,wetsnow,
etc., an alert indicator will illuminate and the left
instrument cluster screen will display:
• CLEANRADAR—SEEMANUAL
• Detectsapproachingvehiclesuptothreecarwidths
from the rear of the vehicle
• UtilizesthesameradarsensorsasBLIS
Rain-sensing Windshield Wipers
• Oncethesystemisturnedon,thereisnoneedforthe
driver to activate, deactivate or adjust the windshield
wipers under normal driving conditions
• Whensensorsmountedbehindtherearviewmirror
detect moisture on the windshield, the windshield
wipers are automatically activated at the appropriate
speed to keep the windshield clear
• Systemmustbeturnedoffbeforeenteringan
automatic car wash
Automatic Headlamps with Wiper Activation
• Automaticallyactivatestheheadlampsandtaillamps
ifthewipersarebeingused—helpingthedriversee
and the vehicle be seen in inclement weather
• Whentheheadlampswitchisinautoposition
and the front wipers are activated in any mode
except mist or wash, the vehicle headlamps will
automatically turn on within 3 seconds
• Oncethefrontwipersaredeactivated,the
headlamps will automatically turn off within
30 seconds
• OnEscapemodelswithautomaticheadlamps
Driver Assistance Technologies cont’d
MAKE THE POINT:
Rain-sensing Windshield Wipers
Be sure to understand and explain the driver-
selectable sensitivity settings on the windshield wiper
stalk. Wet the windshield by using a spray bottle, or
hose, and cycle through the sensitivity settings so the
customer can experience the difference and visually
experience how the system functions. Be sure to also
show the customer how the system is disabled via
the stalk-mounted controls. This is important since
the system must be disabled before entering an
automatic car wash.