OS-7
Startina Svstem
05-7
Removal
installation
1. Disconnect the battery ground cable.
1. Position the starter assembly to the starter mounting
2.
Disconnect the cable and wires at the terminals on
plate and start the mounting bolts.
the solenoid.
2. Snug the starting motor mounting bolts while holding
3. Remove the starter mounting bolts and remove the
the starter squarely against the mounting surface and
starter assembly.
fully inserted into the pilot hole. Tighten the mounting
bolts.
3. Connect the cable and wires to the terminals on the
solenoid. Connect the battery ground cable.
To Next Page
Loading...
Need help?
General
