Fronius MagicWave 3000 Manual

SPt Spot welding time
G-... G-H / G-L: Gas post-flow time
2-step
NOTE!
The welding parameter StS must be set to "OFF" (section Available TIG paramet-
ers). With the power source in its delivery condition, the welding parameter StS is
set to "OFF".
- Welding: Pull back the torch trigger and hold it in this position
- End of welding: Release the torch trigger
I
t
I
H
G-HGAS t
up
t
down
G-L
2-step mode
The explanation of the symbols and abbreviations can be found in the section Symbols
and explanations.
Special 2-step
NOTE!
The welding parameter StS must be set to "ON" (section "Program level prefer-
ences”). With the power source in its delivery condition, the welding parameter
StS is set to "OFF".
- Welding: Pull back the torch trigger and hold it in this position
- End of welding: Release the torch trigger
35
EN-US

Fronius MagicWave 3000 Specifications

General

Brand	Fronius
Model	MagicWave 3000
Category	Portable Generator
Language	English