Fronius SYMO Series User Manual

OFF: No Fronius DATCOM operation at night, the inverter therefore does
not require any power to supply electricity to the Fronius Solar Net
at night.
The inverter display is deactivated at night and the Fronius
Datamanager is not available. To activate the Fronius Datamanager,
switch the inverter on the AC side off and back on and press any
function key on the inverter’s display within 90 seconds.
Contrast
Set the contrast on the inverter display
Setting range 0 - 10
Factory setting 5
Since contrast depends on temperature, it may be necessary to adjust the
‘Contrast’ menu item when environmental conditions change.
Illumination
Preset the inverter display illumination
The ‘Illumination’ menu item only applies to the inverter display background il-
lumination.
Setting range AUTO / ON / OFF
Factory setting AUTO
AUTO: The inverter display illumination is activated by pressing any key. If
no key is pressed for 2 minutes, the display backlight goes out.
ON: The inverter display illumination is permanently on when the invert-
er is active.
OFF: The inverter display illumination is permanently off.
Energy yield The following settings can be changed/performed:
-
Meter deviation/calibration
-
Currency
-
Feed-in tariff
-
CO2 factor
Setting range Currency / Feed-in tariff
Meter deviation/calibration
Meter calibration
Currency
Set the currency
Setting range 3-digit, A-Z
Feed-in tariff
Set the charge rate for the remuneration for energy fed into the grid
Setting range 2-digit, 3 decimal places
39
EN-US

Fronius SYMO Series Specifications

General

Brand	Fronius
Model	SYMO Series
Category	Inverter
Language	English