Commissioning
General
WARNING!
Danger of electric shock!
This can result in severe personal injury and damage to property.
▶
Set the power switch to the "O" position
▶
Disconnect the device from the mains
The commissioning of the power source is described as follows:
- for the main application TIG welding,
- based on a standard configuration for a TIG welding system.
The standard configuration consists of the following components:
- Power source
- Cooling unit
- TIG manual welding torch
- Gas pressure regulator
- Gas cylinder
- Gas cylinder holder
- Trolley
The following steps are intended to provide you with an overview of commissioning the
power source.
For detailed information on the individual steps, refer to the instructions for the corres-
ponding devices.
Notes on the
cooling unit
A cooling unit is recommended for the following applications:
- Robot mode
- Hosepacks over 5 m in length
- TIG AC welding
- General welding in the higher power range
The cooling unit is supplied with power via the power source. When the mains switch of
the power source is switched to position "I", the cooling unit is ready for operation.
Connecting the
shielding gas cyl-
inder
CAUTION!
Danger from falling gas cylinder.
This can result in personal injury and damage to property.
▶
Use safety strap
▶
Secure the safety strap at the height of the upper part of a gas cylinder
▶
Never secure the safety strap to the neck of the cylinder
1
Fix the shielding gas cylinder to the trolley
32
To Next Page
Loading...
Need help?
General
