Manual Metal Arc Welding
Safety
WARNING!
Danger due to incorrect operation.
This can result in severe personal injury and damage to property.
▶
Do not use the functions described here until you have fully read and understood the
Operating Instructions.
▶
Do not use the functions described here until you have fully read and understood all
of the Operating Instructions of the system components, especially the safety rules.
Switch off existing cooling units (see section "Program level preferences”Available
TIG parameters)
WARNING!
Danger of electric shock.
An electric shock can be fatal. If the unit is connected to the grid during installation, there
is a danger of serious injury and damage to property.
▶
Only carry out work on the device if the power switch is in the "O" position
▶
Only carry out work on the device when it has been disconnected from the grid.
Preparation
1
Unplug the mains plug
2
Set the power switch to the "O" position
3
Remove TIG welding torch
NOTE!
The TransTig power source does not have a switchover between the processes
MMA DC- welding / MMA DC + welding.
If the TransTig power source is to be changed from MMA DC- welding to MMA DC +
welding, swap the electrode holder and grounding cable at the welding sockets.
1
Insert the grounding cable into the positive current socket and lock
2
Connect the other end of the grounding cable to the workpiece
3
Insert the welding power-lead into the negative current socket and twist it clockwise
to lock
4
Insert the mains plug
Only if a remote control is used:
1
Connect the remote control to the remote control connection socket
46
To Next Page
Loading...
Need help?
General
