TIG welding
Safety
WARNING!
Danger due to incorrect operation.
Operating the equipment incorrectly can cause serious injury and damage.
▶
Do not use the functions described here until you have fully read and understood the
following documents:
▶
These Operating Instructions
▶
All system component Operating Instructions, especially the safety rules
WARNING!
Danger of electric shock.
An electric shock can be fatal. If the unit is connected to the grid during installation, there
is a danger of serious injury and damage to property.
▶
Only carry out work on the device if the power switch is in the "O" position
▶
Only carry out work on the device when it has been disconnected from the grid.
Preparation
1
Unplug the mains plug
2
Set the power switch to the "O" position
3
Insert the grounding cable into the positive current socket and lock
4
Connect the other end of the grounding cable to the workpiece
5
Insert the welding power-lead of the TIG welding torch into the negative current
socket and twist it clockwise to lock
6
Connect the control plug of the welding torch to the torch control connection and lock
it
7
Equip welding torch (see Operating Instructions for welding torch)
8
Screw the gas pressure regulator onto the shielding gas cylinder and tighten it
When using a TIG welding torch with integrated gas connection:
1
Connect the gas pressure regulator to the shielding gas connection socket on the
rear of the power source using the gas hose
2
Tighten union nut
Only when using water-cooled welding torch and cooling unit:
1
connect the water connections of the welding torch to the water supply and water
return connections of the cooling unit.
2
Insert the mains plug
Only if a remote control is used:
1
Connect the remote control to the remote control connection socket
40
To Next Page
Loading...
Need help?
General
