To Next Page

To Previous Page

5 Tools

308

Tools

Maximum Image Size

Select the maximum image size from [A3], [B4], or [A4] to match the recipient's paper size

or available profile.

Delay Start

Set whether or not to use a delayed start transmission.

If the machine's system clock is set to the 24-hour display, [AM] and [PM] do not appear. For information on the system

clock, refer to "Time" (P.157).

Remote Folder

Select whether or not to send a fax or an Internet fax to a recipient's folder. To use folder

communications, you must obtain the recipient's folder number and passcode in advance.

1 Select [On].

2 Enter a recipient's folder number with the

numeric keypad.

3 If a passcode is set, enter the passcode with the

numeric keypad.

Note • If no passcode is set, leave the text boxes

blank and select [Save].

F Code

Select whether or not to use F code communications.

F Code is the transmission procedure set by the Communications and Information Network

Association of Japan and is the T.30 (communication protocol) method for using sub-

addresses that are standardized by the ITU-T.

For F code (sub address) and password, you can use up to 20 digits 0 to 9, *, and #.

1 Select [On].

2 Enter the F code with the numeric keypad.

Note • The F code consists of "0" + folder number.

For example, if the folder number is 123, the

F code will be "0123".

3 Enter the password as required with the

numeric keypad, and then select [Save].

Note • You can enter up to 20 digits for the

password.

Relay Broadcast

Set the instruction given to a relay station, which is used when the machine is a base station

and the registered speed dial is a relay station for relay broadcast.

When selecting [On], set [Relay Station ID], [Print at Relay Station], and [Broadcast

Recipients].

Fuji Xerox DocuCentre-V C3374 Administrator's Guide

Other manuals for Fuji Xerox DocuCentre-V C3374