Installation When Using USB Port
349
Printer Environment Settings
7
Installation When Using USB Port
This section describes how to install the machine using a USB interface.
The following shows the reference section for each procedure.
Step 1 Preparations .....................................................................................................................................................................349
Step 2 Configuration on the Machine.....................................................................................................................................349
Step 3 Configuration on the Computer ..................................................................................................................................350
CentreWare Internet Services Setting Items.........................................................................................................................350
Step 1 Preparations
The following items are required to connect the machine to a computer via a USB interface.
USB cable
Media (Software/Product Manual) provided with the machine
Step 2 Configuration on the Machine
The following describes the configuration procedures to use a USB interface on the
machine.
Note • To print binary data using a USB interface, set [Adobe Communication Protocol] to [RAW]. For more
information, refer to "USB" (P.214).
• You can configure the settings using CentreWare Internet Services. For items that can be configured
using CentreWare Internet Services, refer to "CentreWare Internet Services Setting Items" (P.350).
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's
passcode, and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3) Select [Tools] on the Services Home screen.
2 Enable the USB port on the machine.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [USB], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
3 Configure [Print Mode] or [Auto Eject Time] as necessary.
For information on the setting items, refer to "USB" (P.214)
4 Select [Close] repeatedly until the [Tools] screen is displayed.
5 Select [Close].
To Next Page
Loading...
Need help?
General
