3 Copy
104
Copy
3
The standard document sizes that can be detected automatically depend on [Paper Size Settings] in the System
Administration mode. For information on the paper size settings, refer to "5 Tools" > "Common Service Settings" > "Other
Settings" > "Paper Size Settings" in the Administrator Guide.
1 Open the document cover.
Important • Make sure that the touch screen is active, and
then load a document. Otherwise, the
machine may not properly detect the
document size.
2 Load the document face down, and align it
against the top left corner of the document
glass.
3 Close the document cover.
Note • When a standard size document is loaded on the document glass, the size of the document is
displayed in the message field.
Step 2 Selecting Features
The following two services are available to copy documents.
Simple Copy
Allows you to only select basic features to copy documents.
Copy
Allows you to make detailed settings to copy documents.
The following describes how to select features on the [Copy] screen.
For information on Simple Copy, refer to "Simple Copy" (P.111).
Note • The features displayed on the screen depend on the configuration of your machine .
• When the Authentication or Accounting feature is enabled, a user ID and passcode may be required.
Ask your system administrator for the user ID and passcode.
Do not apply excessive force to hold thick document on the document glass. It may
break the glass and cause injuries.
To Next Page
Loading...
Need help?
General
