Fuji Xerox DocuCentre-V C4476 User Manual

Fax Procedure
191
Fax
4
• When the [Preview] checkbox is checked, you can preview the read images while reading. For more
information, refer to "Previewing the Read Images during a Fax Job" (P.194).
For information on how to specify a fax number using the Address Book, refer to "Specifying a Destination Using the Address
Book" (P.218).
For information on how to specify a fax number using the speed dialing, refer to "Speed Dialing (Specifying a Destination
Using an Address Number)" (P.223).
For information on how to specify a fax number using one-touch-buttons, refer to "Specifying a Destination Using a One-
Touch Button" (P.226).
For information on the Internet Fax, refer to "About Internet Fax" (P.198).
For information on the IP Fax (SIP), refer to "Internet Fax / Fax / IP Fax (SIP) (Selecting Internet Fax / Fax / IP Fax (SIP))"
(P.217).
Step 4 Starting the Fax Job
The following describes how to start a fax job.
1 Press the <Start> button.
Important • If the document has been loaded in the
document feeder, do not hold down the
document while it is being conveyed.
• Fax cannot be sent if a copy protection code
is detected.
Note • Depending on the settings, the screen to re-
enter the recipient may be displayed after
pressing the <Start> button. In this case, re-
enter the recipient.
• If a problem occurs, an error message
appears on the touch screen. Solve the
problem according to the message.
 If you have more documents
If you have more documents to fax, select [Next Original] on the touch screen while the
current document is being scanned. This allows you to send the documents as one set of
data.
2 While documents are being scanned, select
[Next Original].
Note • When using the document feeder, load the
next document after the machine has
finished scanning the first document.
• You can change the scan settings of the next
document by selecting [Resolution], [Original
Size] and [Lighten/Darken] that are displayed
after selecting [Next Original].
• When this screen or the preview screen is displayed and the time of [Auto Clear] lapsed without any
operation, you can set whether or not to continue the job. For more information, refer to "5 Tools" >
"Common Service Settings" > "Other Settings" > "Paused Job Handling" in the Administrator Guide.
For more information on Auto Clear, refer to "5 Tools" > "Common Service Settings" > "Machine Clock/Timers" > "Auto Clear"
in the Administrator Guide.
<Start> button

Fuji Xerox DocuCentre-V C4476 Specifications

General

Brand	Fuji Xerox
Model	DocuCentre-V C4476
Category	All in One Printer
Language	English