Working with the Tablet PC
Touchscreen
Tou chs cr eenNotes
If the Tablet PC is connected to the optional keyboard cover and is in Clamshell
mode or if the Tablet PC is connected to the optional cradle, never lift or carry the
device by the LCD screen. Excessive stress can damage the LC D screen. Alwa ys lift
or carry t he device with both hands on the base of the keyboard or base.
Information on the screen resolution can be found in the section "Screen resol utions
for inte grated screen and external screens", Page 83.
High-quality LCD screens (TFT) are installed in F ujitsu Tablet PCs. For technical reasons,
these screens are manufactured for a specific re solution. An optimal, clear picture can
only be ensured in the resolution intended for the part icular monitor. A screen resolution
which differs from the specification can result in a blurred pict ure.
The screen resolution of your Ta blet PC’s touchscreen is optimally set at the factory.
As per the current state of production technology, an absolutely error-free screen display cannot be
guaranteed. There may be a few consistently bright or dark pixels (image element s).
Background light ing
LCD screens are operated w ith background lighting. The luminosity of the b ackground
lighting can decrease over the period of use of the Tablet PC. However, you
can set the brightness of your screen yourself.
Ambient light senso r
If your Tablet PC was sh ipped with the Windows operating system, the screen brightness is
regulated by means of the ambient light sensor and depending on the respective light conditions.
This results in optimum readability and longer battery life at the same time.
If your Tablet PC was shipped with Windows 10, the adaptive brightness setting is activated. To
change t he ambient light sensor settings, select Control Panel - System and Security - P ower Options -
Change plan settings - Cha ng e advanced power settin gs - Display - Enable ada pti ve brightness..
Synchronizing the display on the touchscreen and an external monitor
In Windows 10 y ou can proceed as follows to set the output type :
► Wipe your finger over the screen starting from the right-hand edge.
► Select All settings.
► Look fo r the keyword "project".
► Select the requ ired function.
26 Fujitsu
To Next Page
Loading...
Need help?
General