5-1
5. CUSTOMIZING YOUR UNIT
This chapter describes the various options which allow you to set up your unit to
suit your needs. For mode-specific menus, e.g. radar, plotter and sounder, make
sure that you select the appropriate display when making changes or viewing
menu options.
5.1 General Setup
This paragraph shows you how to set up functions common to the plotter, radar
and sounder displays. This is done on the GENERAL SETUP menu, which you
may display from any mode. These items include language, key beep, units of
measurement, data sources, etc.
1. Press the [MENU] key to display the main menu.
2. Press the SYSTEM CONFIGURATION soft key.
3. Press the GENERAL SETUP soft key.
GENERAL
SETUP1
EDIT
NEXT
PAGE
RETURN
GENERAL
SETUP2
EDIT
PREV.
PAGE
Page 1
Page 2
KEY BEEP ON
LANGUAGE ENGLISH
RANGE UNIT nm, kt
TEMPERATURE UNIT
°
F
DEPTH UNIT ft
TEMPERATURE SOURCE NMEA
DEPTH SOURCE NMEA
RESET TRIP LOG NO
LAT/LON DISPLAY DD°MM.MMMM’
TD DISPLAY LORAN C
SPEED SOG
POSITION DISPLAY LAT/LON
TIME DISPLAY 24 HOURS
INFRARED REMOTE MODE A
RANGE & BEARING MODE RHUMB LINE
BEARING READOUT MAGNETIC
MAGNETIC VARIATION AUTO 07.0
°
E
General setup menu
4. Press the NEXT PAGE or PREV. PAGE soft key to switch pages if
necessary.
5. Use the trackball to select item.
6. Press the EDIT soft key.
7. Use the trackball to select option desired, then press the ENTER soft key.
8. Press the [MENU] key to close the menu.
To Next Page
Loading...
Need help?
General
