Furuno MU-190 User Manual

3. OPERATION
22
2. Press the X key to select [SYSTEM].
3. Press the S or T key to select [AUTO DIMMER].
4. Press the W or X key to select an interval to check brightness.
Note: When you connect the monitor unit to FMD-3200, FAR-21x7, FEA-2107, FCR-21x7,
FCR-21x9 or FAR-32x0, set to [OFF].
5. Press the MENU key to close the menu.
3.6.2 How to clear the memory
You can clear the memory to restore the default settings.
1. Press the MENU key to show the menu.
2. Press the X key to select [SYSTEM].
3. Press the S or T key to select [DEFAULT RESET].
4. Press the X key. The indication changes from "NO" to "YES".
Note: To cancel, press the W key. The indication changes from "YES" to "NO".
5. Press the X key to select [RESET].
• [OFF]: Turn of this function. • [3]: Every minute
• [1]: Every two seconds • [4]: Every three minutes
• [2]: Every 30 seconds • [5]: Every five minutes
RGB DVI1 DVI2 VIDEO OSD SYSTEM
AUTO DIMMER
DEFAULT RESET
INFORMATION
RGB : 1280
*
1024 Fh : 80.0kHz Fv : 75Hz
DVI1 : 1280
*
1024 Fh : 64.0kHz Fv : 60Hz
DVI2 : NO SIGNAL
VIDEO
: NTSC
SERIAL No.
: 8073-5578, 987655
APR PROGRAM No.
: 2651020-01.XX
FPGA PROGRAM No.
: 2651021-01.XX
ELAPSED TIME
: 100000
OFF
NO
(OFF, 1~5)
(NO
/
YES)
Signal status,
serial number,
program number
and elapsed time
RGB DVI1 DVI2 VIDEO OSD SYSTEM
AUTO DIMMER
DEFAULT RESET
INFORMATION
RGB : 1280
*
1024 Fh : 80.0kHz Fv : 75Hz
DVI1 : 1280
*
1024 Fh : 64.0kHz Fv : 60Hz
DVI2 : NO SIGNAL
VIDEO
: NTSC
SERIAL No.
: 8073-5578, 987655
APR PROGRAM No.
: 2651020-01.XX
FPGA PROGRAM No.
: 2651021-01.XX
ELAPSED TIME
: 100000
OFF
YES
(OFF, 1~5)
(NO
/
YES)
ALL CUSTOM SETTINGS WILL BE LOST.
← KEY: CANCEL → KEY: RESET

Furuno MU-190 Specifications

General

Brand	Furuno
Model	MU-190
Category	Monitor
Language	English