190-02692-00 Rev. A
Garmin G1000 Pilot’s Guide for the Piper PA-32 Saratoga 347
HAZARD AVOIDANCE
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICES INDEX
SYSTEM STATUS
The system performs an automatic test of TIS during initialization. If TIS passes the test, TIS enters Standby
Mode (on the ground) or Operating Mode (in the air). If TIS fails the initialization test, the system displays an
annunciation in the center of the MAP - TRAFFIC MAP Page.
MAP - TRAFFIC MAP
Page Center Banner
Annunciation
Description
NO DATA Data is not being received from the transponder*
DATA FAILED Data is being received from the transponder, but a failure is detected in the data stream*
FAILED The transponder has failed*
UNAVAILABLE TIS is unavailable or out of range
* Contact a service center or Garmin dealer for corrective action
Table 6-21 TIS Failure Annunciations
Figure 6-83 TIS Initialization Test Failure
Data Not
Received from
Transponder
System Test has
Failed
The traffic mode is annunciated in the upper left corner of the MAP - TRAFFIC MAP Page. When the aircraft
is on the ground, TIS automatically enters Standby Mode. If traffic is selected for display on another map while
Standby Mode is selected, the traffic display enabled icon is crossed out (also the case whenever TIS has failed).
Once the aircraft is airborne, TIS switches to Operating Mode and traffic information is displayed. The mode
can be changed manually using softkeys or the page menu.
To Next Page
Loading...
Need help?
General
