GE AKTA GO User Manual

ActionStep
Insert the waste tubing from all installed modules in a suitable vessel.1
Cut the waste tubing to appropriate length. It is important that the tubing
is not bent.
2
Note:
If the tubing is too short, replace it with new tubing. Do not lengthen the tubing
as this might cause obstruction of the tubing.
Fasten all waste tubing to the waste vessel.3
ÄKTA go Operating Instructions 29360951 AC 47
4 Installation
4.2 Hardware installation
4.2.2 Install waste tubing

GE AKTA GO Specifications

General

Brand	GE
Model	AKTA GO
Category	Laboratory Equipment
Language	English