• To accept a shortened version of the word, press
F3
to accept the word. Then move
the cursor to the unnecessary characters and press ¶ to delete them.
• To reject the word, continue entering text as normal.
• Press the µ¶ keys to scroll through the list of word library words.
• To disable the word library:
1. Navigate with the µ¶ keys to Word Library and press OK.
2. The current state of the word library is displayed. In this case, it is enabled.
3. Use the
µ¶
keys to change the state to disabled and press
OK
.
4. The keypad beeps once to accept the change and returns to Word Library.
3.3 Installer message
Up to four messages can be displayed on the LCD when the keypad is idle or when it
times out from a menu. If you enable more than one message, the messages are shown
in a continuous cycle.
• Installer message
You can define a message of up to two lines long that is displayed by default. You
can enable or disable this message.
• Date and time
The current system date and time. You can edit, enable or disable this message.
• Service required
A service message that is displayed when a system fault occurs. You cannot edit
this message but you can enable or disable it.
•
System ready/not ready
The status of the system. You cannot edit or disable this message.
To enable the installer message:
1. Navigate with the
µ¶
keys to This Keypad and press
OK
.
2. Select Keypad Features>Display and press OK.
3. Scroll to Custom Message and press OK. The current status of the installer
message is displayed. In this case, it is disabled.
4. Use the
µ¶
keys to change the status to enabled and press
OK
.
5. The keypad beeps once to accept the change and returns to Custom Message.
To Next Page
Loading...
Need help?
General