The brackets contain the additional digits for 6-digit codes.
1.2 LCD keypad (CS5500)
The CS5500 LCD keypad allows you to program the CSx75 system using a menu
structure.
Power (green)
• On if the system is connected to the mains and the battery is OK.
• Flashes if the system has no battery or a low battery.
•
Off
if the system is not connected to the mains.
Ready (green)
• On when the system is ready to arm.
•
Flashes
when the system is ready to force arm.
• Off when the system cannot be armed.
Fire (red)
• On when a fire zone has been activated.
• Flashes when there is a problem with a fire zone.
• Off when all fire zones are operating correctly.
Function keys
• Press F1 to scroll to the start of the LCD message.
• Press F3 to scroll to the end of the LCD message.
In multi-area mode, these keys have specific functions. If you select one
or more areas in this mode:
• Press F1 to part arm the set of areas.
• Press
F2
to full arm the set of areas.
• Press F3 to disarm the set of areas.
You can program these keys to perform a function when not in multi-
area mode. To do this, select Installer Menu>This Keypad>Function
Keys. For more information on navigating the menus, see page 9.
No
Press
No
to:
• Cancel a change to the menu selection or
• Navigate to a higher level in the menu structure or
• Cancel a sequence when entering numeric data.
To Next Page
Loading...
Need help?
General