GE NetworX NX-1192E User Manual

8
III. ARMING / DISARMING YOUR SYSTEM
A.
ARMING IN THE “AWAY” MODE
AWAY is utilized when the user is going away from the premise and wants the interior
protected. Listed below are the steps to arm in the AWAY Mode:
1.
Close all protected doors and windows.
¾
Ready light
will be on or flashing when all protected zones and sensors are
secure.
NOTE: If any zones are
bypassed, a sensor in that zone
can be violated without affecting
the
ready light
.
¾ The security system will not arm if
the
ready light
is off. Refer to
"Making Your System Ready to
Arm".
¾ If the
power light
is off, you have no
AC power. Restore power if possible. If not, contact the installing company.
2.
Enter your 4 or 6 digit user code to arm the system.
¾ The
armed and exit lights
will illuminate.
¾ You may now leave the building.
(
IMPORTANT! The
exit light
will flash rapidly for the last 10 seconds of the
exit delay as a warning to the user that the exit time is about to expire. The user
may wish to disarm and rearm the system if more time is needed.
B.
MAKING YOUR SYSTEM READY TO ARM
If the
ready light
is not on or if it is flashing, a zone is not secure. To identify this zone,
use the scroll keys
x
y
to the right of the display to browse through the zones that
are not normal. If you wish to bypass or unbypass one of these zones, press
BYPASS
while that zone is being displayed. When finished viewing the zones, press
À
to return
to the code entry screen.
6\VWHP5HDG\
7\SH&RGHWR$UP
6\VWHP1RW5HDG\
)RUKHOSSUHVV

6\VWHP$UPHG
$OO=RQHV6HFXUH

GE NetworX NX-1192E Specifications

General

Brand	GE
Model	NetworX NX-1192E
Category	Keypad
Language	English