GE NetworX NX-1192E User Manual

11
1.
Enter a valid user code.
2.
The red
armed light
will go off and
the tone will stop. The security system is now DISARMED. If a valid code is
not entered before the end of the entry delay, an alarm will occur.
NOTE: If
the red
armed light
is flashing during the entry delay, the alarm system
has been activated in your absence. Leave the building immediately and
call your alarm company and/or the police from a safe location.
IV. CANCEL / ABORT FEATURE
(Optional if programmed)
The
cancel light
will flash during an abort delay time. If a code is entered followed by
CANCEL
while this light is flashing, all abortable reports will stop the communication
process.
NOTE: The abort feature must be enabled
. Entering a code followed by
CANCEL
during or after an alarm report to the central station will cause the
cancel light
to come on. It will stay on until the central station has received the cancel report.
NOTE:
The cancel feature must be enabled.
V. BYPASSING ZONES
If you wish to bypass one or more zones, this must be done while the system is in the
disarmed state. If the zone is not known, refer to Procedure #2.
PROCEDURE #1: If you know the number of the zone to bypass, use the following:
1.
Press
BYPASS
.
2.
When the LCD prompts for a code (optional, if programmed), enter your user
code.
3.
The
bypass light
flashes.
4.
Enter the zone you wish to bypass. (Example:
]
for zone 6 or
X X Y
for zone 112.)
5.
Press
BYPASS
again. The zone is now bypassed.
7\SHFRGHWR
'LVDUP

GE NetworX NX-1192E Specifications

General

Brand	GE
Model	NetworX NX-1192E
Category	Keypad
Language	English