¾ The LCD display will read
“Instant” meaning the
entry/exit doors do
NOT
have
an entry delay.
D.
USING THE QUICK ARM
The Quick Arm feature may be used if it is enabled. Quick Arm will allow the user to arm
the security system in the AWAY mode by pressing
EXIT
. The system can be quick
armed in the STAY mode by pressing [
STAY
]. This feature is used for ARMING ONLY,
and will not disarm the security system. This is ideal for a maid or baby sitter code, etc.
E.
CHANGING MODES WHILE YOUR SYSTEM IS ARMED
1.
Pressing
STAY
will turn on/off (toggle) a delay on Entry/Exit doors. The
“Instant” message will toggle on the LCD display.
2.
(Optional, if programmed.) Press
BYPASS
at this time to turn on/off (toggle)
all designated interior zones. If all interior zones are not bypassed, the
stay
light
will extinguish.
3.
(Optional, if programmed.) When armed, pressing
EXIT
will start the exit
delay, enabling you to leave the building.
(
IMPORTANT!
An alarm will be created if the “
Instant
” message is ON at this
time and you re-enter the building. You may re-initiate an entry/exit delay by pressing
STAY
again. The “
Instant
” message will disappear.
F.
DISARMING YOUR SYSTEM
When you enter the protected area through one of the designated Entry/Exit doors, the
keypad control will sound a continuous tone for the duration of the entry delay time, or
until you enter a valid code.
6\VWHP$UPHG
,QVWDQW
To Next Page
Loading...
Need help?
General