23
To disarm
all
of these areas, press
x
To arm
all
of these areas, press
y
To toggle a single area between the armed and disarmed conditions, press
À
[
Area number
]. For example: If Area 4 is armed,
À
[
will disarm Area 4. If Area
4 is disarmed,
À
[
will arm it.
Press
STAY
during the exit delay to bypass all interior zones in the exit delay.
To control the individual areas, refer to the following section.
C.
INDIVIDUAL AREAS IN THE MULTI-PARTITION MODE
Enter a code that is a valid arm/disarm code for the area you wish to operate. The
following display will appear on the LCD screen.
Only the areas authorized by this code will
appear.
To toggle between the armed and disarmed states of an individual area, press
À
area
number
.
To operate an individual area, enter the number of the partition you wish to operate.
The LCD keypad will now operate as a single area keypad. All keys and functions
entered will affect this individual partition only. The lights and display represent the
status of that partition only. The word "System" will be replaced with the word "Area #".
The following is an example of this feature. To exit this screen, press
.
Area 5 is selected and Area 5 is ready to
arm. To exit the individual partition mode,
enter
D.
SILENCING ALARMS IN THE MULTI-PARTITION MODE
If the keypad is sounding an alarm or the siren is running, it can be silenced by
entering a code with the authority for the area(s) that are in alarm.
NOTE
: The
EXIT
,
BYPASS
, and
STAY
keys will only work if an individual partition is selected.
³'LVDUP
$UP
$UHD5HDG\
7\SHFRGHWRDUP
To Next Page
Loading...
Need help?
General