GE NetworX NX-1192E User Manual

9
C.
ARMING IN THE “STAY” MODE
STAY is utilized when the user is inside the premise and wants protection around the
perimeter. The steps to arm in the STAY Mode are as follows:
1.
Close all protected doors and windows.
¾
Ready light
must be on or flashing (force armed) when all protected zones
and sensors are secure.
NOTE: If any zones are bypassed, a sensor
in that zone can be violated without affecting the
ready light.
¾
The security system will not arm if the
ready light
is off or flashing.
¾
If the
power light
is off, you have no AC power. Restore power if possible.
If not, contact the installing company for service.
2.
Enter your 4 or 6 digit user code.
(Optional, if programmed.)
¾
If “Auto Bypass” is enabled, all
interior zones will be bypassed
if you do not leave through a
designated entry/exit door. If Auto Bypass is enabled, omit Step 3.
¾
When “Auto Instant” is enabled, if you do not leave through a designated
entry/exit door, the display will read “
Instant
”, indicating that the entry/exit
doors no longer have an entry delay. If “Auto Instant” is enabled, omit
Step 4.
3.
Press
STAY
.
¾
The
stay light
will illuminate indicating that all interior zones are bypassed.
(All interior devices will bypass automatically, giving the user freedom of
movement within the interior area.)
¾
The
bypass light
will illuminate if any zone(s) are bypassed. If any
zone(s) have been bypassed previously by the user, the light(s)
corresponding to the bypassed zone(s) will illuminate, alerting the user
that a zone(s) may be unprotected and can be faulted without an alarm.
4.
To toggle from a “delayed entry” mode to an “Instant” mode, press
STAY
again.
6\VWHP5HDG\
7\SHFRGHWRDUP

GE NetworX NX-1192E Specifications

General

Brand	GE
Model	NetworX NX-1192E
Category	Keypad
Language	English