– 58 –
Machine Compartment Cover
The machine compartment cover is held to the rear
of the refrigerator with six 1/4-in. hex-head screws.
After removing the screws, the cover can then be
lifted from the 2 bottom tabs.
Note: When installing the machine compartment
cover, be sure to place the 2 cover tabs behind
chassis before installing screws.
Cover Tab Cover Tab
Chassis
Note: The machine compartment cover must be
properly installed to ensure air passes thru the
condenser.
Disconnect
Ice Box Fan
Air Duct
5. Using a fl at blade screwdriver, pry the top 2 lock
tabs up, lower the fan, and release the bottom 2
lock tabs from the air duct.
Lock Tab
To remove the ice box fan:
1. Remove the freezer evaporator cover. (See
Freezer Evaporator Cover.)
2. Disconnect the ice box fan wire harness.
Note: The ice box fan wire connector also contains
the freezer evaporator thermistor connections.
3. Remove the evaporator thermistor from the
thermistor clip attached to the evaporator.
Note: In the following steps, the ice box fan is
attached to the air duct with a screw and 4 lock
tabs.
4. Remove the 1/4-in. hex-head screw from the ice
box fan.
Caution: To prevent damage, make sure the
freezer evaporator thermistor is installed under the
thermistor clip attached to the evaporator.
To Next Page
Loading...
Need help?
General
