– 75 –
Clamp
4. Remove the plastic lock clip off the coupling
and push the collar in while pulling the fi lter
inlet tube out from the connector located at the
rear of the cabinet. Remove the inlet tube from
retainer.
Retainer
Connector
Lock Clip
Water Filter Manifold
The water fi lter manifold for model PFE29 is located
behind the water fi lter access door. It is attached to
the left refrigerator door with 2 upper and 2 lower
tabs and a Phillips-head screw.
To remove the water fi lter manifold on Model PFE29:
1. Remove the water fi lter. (See Water Filter.)
2. Place the hinge cover in the service position.
(See Hinge Cover.)
3. Remove the 1/4-in. hex-head screw and clamp
from the fi lter inlet tube.
5. Pull the fi lter inlet tube out of the tubing conduit
at the top of the cabinet.
6. Slide the spring off the fi lter inlet tube.
Spring
Note: In the following step, the fi lter door has 2 tabs
located inside, above the hinge, that attach it to the
refrigerator door. Either tab can be pressed inward
to release the fi lter door.
Tab
Hinge
Tab
(Continued next page)
Note: See note on page 40 regarding lock clips.
To Next Page
Loading...
Need help?
General
