– 65 –
Note: Before performing the following step, take
notice of the position of the duct door return spring.
10. Using a fl at blade screwdriver, gently pry the
duct door motor out from the motor bracket.
11. Move the motor, return spring, and duct door as
an assembly to the right, then remove the duct
door from the door bracket at the left.
Return Spring
Duct Door Motor
Motor Bracket
Door Bracket
(Continued next page)
Actuator Paddle, Switch, and Lower Ultrasonic
Sensors
Note:
• The paddle switch is a 2-position switch with 3
wires. It has a normally open and a normally
closed contact.
• Both the door board and user interface board
(UI) look for a change of state of both contacts
when the paddle is depressed before the
selected function is activated.
• The door board monitors 1 of the contacts and
the user interface board (UI) monitors the other
contact.
• The paddle and switch are attached to the
dispenser recess with 2 top pins and 2 bottom
tabs located inside.
To remove the actuator paddle and switch:
1. Remove the funnel. (See To remove dispenser
assembly components, follow steps 1 thru 9.)
2. Disconnect the actuator switch wire harness.
3. Using a small fl at blade screwdriver, gently pry
inward and disengage each top pin from the
dispenser recess and then pull the paddle up.
Disconnect
To Next Page
Loading...
Need help?
General
