– 71 –
To remove the fresh food door icemaker:
Note: The icemaker is located inside the left-side
refrigerator door.
1. Open the ice box door and remove the ice
bucket.
2. Remove the 5/16-in. hex-head screw from the
wire harness cover.
Cover
Under normal operating conditions, the icemaker
is capable of producing approximately 100-130
cubes (approximately 4.3 pounds of ice) in a 24-
hour period. The rate of ice production depends
on freezer and ice box compartment temperature,
room temperature, number of door/drawer
openings, and other use conditions.
During the service diagnostic test, the feeler arm
position sensor and motor position sensor are
tested by the control board software. The motor
and water valves are energized and can be visually
observed for diagnostic purposes.
4. Disconnect the icemaker wire harnesses.
5. Remove the bottom center and the right side
5/16-in. hex-head screws (right-side screw
omitted on some models) that attach the
icemaker to the ice box.
6. Lift and remove the icemaker.
Disconnect
Disconnect
3. Lift the bottom of the wire harness cover then
remove the cover.
Lift
(Continued next page)
To Next Page
Loading...
Need help?
General
