– 24 –
Range Components
Hinge lock (unlocked position)
Slot
Hinge arm
Door Assemblies
The doors can be separated into two assemblies:
(1) Outer assembly which consists of handle,
vent trim, outer glass, bottom trim, and frame; (2)
Inner assembly which consists of inner panel,
gasket, glass panels, and insulation. The
assemblies are held together by 2 screws on
each side, along with 4 screws across the
bottom.
Caution: Care must be taken when mounting
door handle not to overtighten handle screws.
Overtightening screws can damage handle.
Hand-tighten screws (do not use electric driver).
Make sure handle fits snugly to door panel.
Self-Clean Door Gasket - The door gasket is
attached to the inner door panel by a chain of
spring clips.
1. Locate spring clip at center of gasket and
insert in hole on inner door panel near top.
2. Install gasket by bending at 90° beside clip
and rocking into hole.
3. Tuck loose ends into slot at the bottom of
inner panel.
Stainless Steel Door (On some models)
The stainless steel door has an additional third
pane of glass and an additional piece of insulation
inside the inner door assembly, at the bottom of
the window pack. It is the same piece of insulation
that is used across the top of the window pack.
There is also a piece of
1
/8-in. thick foil faced
insulation across the top of the door, just behind
the handle. It gets sandwiched under the inboard
pair of screws that mount the door handle to hold
it in place.
Finally, there are two strips of adhesive backed foil
tape, approximately 4-in. wide and 12-in. long,
along each side of the window. These are applied
vertically (one on each side) to the glass and
frame assembly, before the handle is attached.
Oven Door
WARNING: Before servicing the range, power
and/or gas must be removed from the range.
Make sure the oven is completely cool.
To remove the door:
1. Fully open the door.
2. Pull the hinge locks down toward the door
frame, to the unlocked position. This may
require a flat-blade screwdriver to start the
hinge locks moving.
3. Firmly grasp both sides of the door at the top.
4. Close the door to the door removal position,
which is halfway between the broil stop
position and fully closed.
Caution: Do not lift the door by the handle.
5. Lift the door up and out until the hinge arm is
clear of the slot.
To Next Page
Loading...
Need help?
General