– 41 –
Testing the Flame Stability
Test 1: Turn the knob from HI to LOW quickly. If
the low flame goes out, increase the flame size
and test again.
Test 2: With the burner on LOW setting, open and
close the oven door quickly. If the flame is
extinguished by the air currents created by the
door movement, increase the flame height and
test again.
Maintop Burner Assembly
WARNING: Shut off gas to the range before
proceeding.
The maintop burner assembly comes out of the
range as one unit.
To remove the maintop burner assembly:
1. Remove the iron burner grates, burner caps,
and burner heads from the glass cooktop.
4. Open the door and remove the 5 hex-head
screws under the control panel frame.
Remove the control panel frame.
5. Unplug the left connector at the front corner of
the maintop burner assembly.
2. Remove the control panel assembly (see
Keypanel and ERC).
3. Remove the 5 hex-head screws from the top
inside edge of the control panel frame.
Burner Grate
Burner Cap
Burner Head
Glass Maintop
7. Disconnect the gas manifold pipe coupling on
the right side corner of the maintop burner
assembly.
Left Corner Right Corner
6. Remove the 2 hex-head screws at the front
corners of the maintop burner assembly.
8. Slide the maintop burner assembly forward
and remove. Place it top-side-up on a
protected surface.
Gas Coupling
Unplug
To Next Page
Loading...
Need help?
General