GE Profile J2S968 SERIES User Manual

– 43 –
4. Roll the lower heat shield back to access oven
components.
Note: When reassembling, it is important that the
seal on the lower heat shield is in place; it is
located on the bottom edge (see photo). Replace
if damaged or worn.
Seal
Lower Heat Shield
Upper and Lower Heat Shields
The upper and lower heat shields are located
under the maintop burner assembly.
To remove the upper and lower heat shields:
1. Remove the maintop burner assembly (see
Maintop Burner Assembly).
2. Remove the 6 hex-head screws that hold the
upper heat shield in place. Remove the upper
heat shield.
Note: For proper operation, air to the burners is
supplied only from around the burner knobs.
When reassembling, it is important that all seals
on the upper heat shield are in place (see photo
below). Replace any damaged or worn seals.
3. Open the door then remove the 3 hex-head
screws that hold the lower heat shield in
place.
Upper Heat Shield
Seals

GE Profile J2S968 SERIES Specifications

General

Brand	GE
Model	Profile J2S968 SERIES
Category	Ranges
Language	English