Appendix A Product Certifications and Installation Guidelines
For public disclosure
Appendix A Product Certifications and
Installation Guidelines
The QuickPanel
+
Operator Interface is intended for use in industrial environments and, when properly installed, shall
comply with the agency approvals listed in this document.
Agency Approvals
Note The agency approvals listed in the following table and on the Declaration of Conformities are believed to be
accurate; However, the product’s agency approvals should be verified by the marking on the unit itself.
N.A. Safety for Programmable Controller for use in
Hazardous locations
Class I Division 2 Groups A, B, C, D (applicable to
7'', 10'', 12'', and 15” Display units)
Class I Division 2 Groups A, B, C, D; Class 2
Division 2 Groups F, G; Class 3 Division 1 and
Division 2 (applicable only to 6'' Display unit)
Certification by Underwriter's Laboratories to UL
61010-1; UL61010-2-201;
CSA C22.2 No 142 – M1987; CSA 61010-1; CSA
61010-2-201
ISA 12.12.01 standard and CSA C22.2 No
213-M1987
Explosive Atmospheres Directive European
Safety for Hazardous Areas
Equipment Group II, Category 3, Gas Groups IIC, Dust
Group IIIC
Certification in accordance with the ATEX Directive
14/34/EU with an Independent 3rd Party
Assessment Certificate only applies to the 12” and
15” Display units: EN 60079-0/A11,
EN 60079-15, and EN 60079-31;
Part numbers: IC755CSW07CDACA,
IC755CSS10CDACA,
IC755CSS12CDBCA,
IC755CSS15CDACA
Electromagnetic Compatibility Directive
European Electromagnetic Compatibility (EMC)
for Industrial Control Equipment
Self-declaration in accordance with European
Directives EN61000-6-2, EN61000-6-4
Maritime Society Certification
No
Marking,
verified
by
certificate
American Bureau of Shipping (ABS), Det Nortske
Veritas/Germanischer
Lloyds (DNV-GL), and Bureau
Veritas (BV) certification on conformal coated 6, 7,
10, 12, 15” units only
To Next Page
Loading...
Need help?
General