5.6 Battery Installation and Replacement
Batteries may present a risk of fire, explosion, or chemical burn if mistreated. Do
not crush, disassemble, short-circuit, or dispose of in fire.
Warning
Use of batteries not specified for use with the QuickPanel
+
product may present a
risk of fire or explosion.
Warning
Do not recharge, disassemble, heat or incinerate lithium batteries.
Dispose of lithium batteries in accordance with federal, state, and local regulations.
Be sure to consult with the appropriate regulatory agencies before disposing of
batteries.
1) Replacing the battery should only be performed by trained personnel and in
a non-hazardous location.
2) If the QuickPanel
+
Operator Interface is VESA mounted, detach from the VESA
arm when replacing the battery.
3) The battery should only be replaced when the unit is powered off.
Caution
4) Care should be taken to protect and insert the battery with correct polarity.
5) Do not use any metallic item to remove the battery (such as screwdrivers,
knives, pliers, and so forth).
6) Be careful to not drop the battery or any associated screws into the unit.
7) Be careful of edges on internal sides of the enclosure and frame.
Attention
The PC controller does not start automatically when the battery is replaced in
QuickPanel
+
Operator Interface. After battery replacement, start the controller
using the #Command in the Proficy Machine Edition (PME) runtime.
To Next Page
Loading...
Need help?
General