Packaging - Shipping and storage
Packaging - Identification - Storage
GE Information L22- 027EN/04
5/6
03- 2017
Storage
Introduction
The storage procedures defined below are for storage times of less than 2
years. For longer periods, special packaging must be designed and
appropriate procedures devised.
Short- term storage
(6 months)
The apparatus must be stored in its transport packaging and placed on beams
in a flood- proof place.
Medium- term storage
(less than 2 years)
The table below indicate how to stock the main components of the
circuit- breaker for a medium- term storage :
Component Storage
Components
of the circuit- breaker pole
The apparatus must be stored with its
transport packaging open whilst
placed on beams in a closed (indoor),
but ventilated, flood- proof place.
Operating device
The operating device should be
stored in the same place as the
circuit- breaker, these two
sub- assemblies being inseparable.
Check that the packaging is
leak- tight.
If this has been damaged, proceed as
follows :
S The operating device should be
placed so that air can enter through
the vents of the rear plate and side
panels.
S In order to prevent corrosion
damage due to formation of
condensation, it is mandatory that the
heating circuit be switched on.
Continued on next page.
To Next Page
Loading...
Need help?
General
