Chapter 8. Servicing the PT878
194 Transport® Model PT878 Portable Liquid Flowmeter User’s Manual
8.11 Resetting to Factory Default Parameters
For various reasons, you might wish to return the PT878 to its original
settings. The Factory Defaults option enables you to return the meter to its
preprogrammed default settings. To enter the option, scroll down to the
Factory Defaults entry in the Service Menu and press
[ENTER]. The screen
will appear similar to Figure 129 below.
Note: All sites and logs will be lost if you use the Factory Defaults option.
Be sure to transfer or print all sites and logs before resetting!
Figure 129: Factory Defaults Option
1. To restore Factory Default settings:
• Press [F2] (Cancel) to return to Operate Mode without changing the
current settings.
• Press [F3] (OK) to confirm that you wish to restore the factory default
settings.
2. The program asks for confirmation: “Are you SURE?” Repeat the
procedure shown in Step 1 above.
The PT878 replaces the default site file and the global meter settings with
the factory default settings, and returns to Operate Mode.
Factory Defaults
Cancel OK
*** WARNING ***
You will LOSE all changes by
pressing OK.
Choose CANCEL to exit or OK to
proceed.
To Next Page
Loading...
Need help?
General
