gefran BDI50 Series User Manual

3-1
Chapter 3 Environment & Installation
3.1 Environment
Installation environment has a direct effect on the correct operation and the life expectancy of the
inverter, Install the inverter in an environment complying with the following conditions:
Protection
Protection
class
IP20
Suitable environment
Operating
temperature
-10~40°C (size 1) -10~50°C (other sizes)
If several inverters are installed in the same control panel, ensure
adequate spacing and provide the necessary cooling and ventilation for
successful operation.
Storage
temperature
-20~60°C
Relative
Humidity
Max 95% (without condensation)
Altitude
Altitude
：
Below 1000m (3281ft)
It is required to reduce 2% of inverter rated current at each additional
100m. The maximum altitude is 3000m
See ch. 3.2.3 Derating curves.
Shock
2G (19.6m/s²) for 57~150Hz and below.
0.3mm for 10~57Hz (According to IEC60068-2-6 standard)
Installation site
Install in an environment that will not have an adverse effect on the operation of the unit
and ensure that there is no exposure to areas such as that listed below:

Direct sunlight, Rain or moisture
 Oil mist and salt
 Dust, lint fibres, small metal filings and corrosive liquid and gas
 Electromagnetic interference from sources such as welding equipment

Radioactive and flammable materials
 Excessive vibration from machines such as stamping, punching machines
 Add vibration-proof pads if necessary

gefran BDI50 Series Specifications

General

Brand	gefran
Model	BDI50 Series
Category	Inverter
Language	English