1-3
1.4 During Operation
Danger
Do not connect or disconnect the motor during operation. Otherwise, It may
cause the inverter to trip or damage the unit.
Do not touch heat radiating components such as heat sinks and brake resistors.
The inverter can drive the motor from low speed to high speed. Verify the allowable
speed ranges of the motor and the associated machinery.
Note the settings related to the braking unit.
Risk of electric shock. The DC link capacitors remain charged for five minutes after
power has been removed. It is not permissible to open the equipment until 5
minutes after the power has been removed.
The Inverter should be used in environments with temperature range from
-10… +40°C / 14…104℉ (size 1) or -10…+50°C / 14…122℉ (all other
sizes) and relative humidity of 95%.
Danger
Make sure that the power is switched off before disassembling or checking
any components.
1.5 Inverter Disposal
Caution
Please dispose of this unit with care as an industrial waste and according to your
required local regulations.
The capacitors of inverter main circuit and printed circuit board are considered as
hazardous waste and must not be burnt.
The Plastic enclosure and parts of the inverter such as the cover board will release
Danger
To avoid electric shock, do not take the front cover off while power is on.
The motor will restart automatically after stop when auto-
restart function is enabled.
In this case, care must be taken while working around the drive and associated
equipment .
The o
peration of the stop switch is different than that of the emergency stop switch.
The stop switch has to be activated to be effective. Emergency stop has to be
de-activated to become effective.
To Next Page
Loading...
Need help?
General