gefran BDI50 Series User Manual

4-84
2nd
entry
</ENT
▲
▼
or
</ENT
Set Password successfully
Set Password failed
▲
▼
or
</ENT
The Parameter Lock Key Code STATUS become: 00002. User has no access to
parameters setting.
2.3 After step 2.2, the procedure to UNLock the access to all parameters is the following:
Lifting
Password
</ENT
▲
▼
or
</ENT
Password successfully lifted
Password failed to lift
▲
▼
or
</ENT
3. Lost password recovery
If a password set by customer is lost, please contact Gefran Service Team for assistance.
13- 08
Reset Drive to Factory Settings
Range
【
1150
】
: Reset to factory setting (50Hz,220V/380V system)
【
1160
】
: Reset to factory setting (60Hz,220V/380V system)
【
1250
】
: Reset to factory setting (50Hz,230V/400V system)
【
1260
】
: Reset to factory setting (60Hz,230V/460V system)
【
1350
】
: Reset to factory setting (50Hz,220V/415V system)
【1360】: Reset to factory setting (60Hz,230V/400V system)
 When a Parameter lock key number has been entered in parameter 13 – 07. This key
number must be entered first before parameter 13-08 can be used.
 Reset 13-08 to default setting will reset parameter 02 group.
 For built-in EMC filter models, the default setting of 13-08 is “1250”.
For without built-in EMC filter models, the default setting of 13-08 is “1360”

gefran BDI50 Series Specifications

General

Brand	gefran
Model	BDI50 Series
Category	Inverter
Language	English