GHL Doser 2.1 User Manual

GHL Doser Resource Guide
Release 07/2018
36
12. After the update is completed, restart the doser, and reconnect.
Need a visual?
You can see our how-to update GHL Doser SA firmware video by clicking the
link below.
How to update GHL Doser Standalone firmware:
https://youtu.be/3YFCHb_VXnQ
How to Add a Slave Doser to a SA Doser or ProfiLux
If you purchased a GHL Doser Slave, you can connect it to the standalone GHL Doser 2 / 2.1 /
Maxi. The slave Doser 2.1 can also be connected to a Profilux 3 or 4 controller.
A slave doser can be daisy chained via a PAB cable; a GHL Doser 2 SA or 2.1 SA or Profilux 3 or
4 must be present. Please note that a PAB cable is not included with the slave doser and will
therefore be needed before continuing with this setup.
To add a GHL Doser Slave to an existing standalone Doser 2.1 /Maxi or Profilux 3 or 4, please
follow these steps:
1. Connect all cables and tubing to the slave doser.
2. Connect the Slave Doser to the GHL Doser SA using a PAB cable.
3. Connect to the Standalone Doser using GHL Control Center.
4. Click on “System”
5. Click on “Assign Devices”. A new window will pop up and your slave Doser 2 will be
displayed there.

GHL Doser 2.1 Specifications

General

Brand	GHL
Model	Doser 2.1
Category	Water Pump
Language	English