GHL Doser Resource Guide
Release 07/2018
40
To convert a GHL Doser SA to operate as a slave, please follow these steps:
1. Connect to the Doser SA via USB which will become the slave.
2. Once connected, look at the bottom of the “General” settings page and select “Slave”
from the dropdown box.
3. Save settings.
4. Disconnect the USB cable from the “now” slave doser and connect it to the SA Doser
which will be used as the master dosing unit using a PAB-cable.
5. Assign this now slave doser to the Doser SA, see How to Add a Slave Doser to a SA
Doser or ProfiLux.
How to Update GHL Doser Slave Firmware
After each Doser SA or ProfiLux firmware update, it is recommended that you also keep the
firmware of your PAB-Devices up-to-date. This also includes Native Slave Dosing units.
NOTE: Standalone dosers converted to SLAVE
If you have one or more Standalone dosers converted to SLAVE mode,
please note that these particular units are native Standalone units. To update
the firmware of native Standalone dosers convered to SLAVE, please follow
the steps shown here.
***UPDATES SHOULD ONLY BE PERFORMED IN GHL CONTROL CENTER VIA USB***
NOTE: Only the PAB-device which will be receiving the update should be connected
to the Doser SA or ProfiLux. Disconnect all other PAB devices from the Doser SA or
ProfiLux before proceeding any further.
To update the firmware on your GHL Doser Slave, please follow the steps below.
1. Go to “System” and double-click “PAB”. Your GHL Doser Slave units will be listed.
2. Select the correct GHL Doser Slave unit and click on “Firmware Update”
To Next Page
Loading...
Need help?
General