COOL mode operation
Under this mode, the temp. setting range is 16℃～30℃.
Note:
Press FAN speed to set fan
speed.
Press swing button, the gui-
de louver will swing automatic-
ally, when repressed, it will stop.
Press the button, to set the
desired temperature.
Press MODE button to
select COOL mode.
After powered on, press 1/0
unit will start to run.button,
Microcomputer will accord to the temp. differences which is between the detected temp.by the sensor and the setting temp.
to decide to run in COOL mode or not.
If the temp. which is detected by the room sensor is higher than the setting temp., compressor will run in COOL mode.
If the temp. which is detected by the room sensor is lower than the setting temp., compressor will stop running,
only the indoor fan run at the setting speed.
Bird Single-Split Type
To Next Page
Loading...
Need help?
General
